There are 46 items currently available.
Battery01
Battery 12V 2200 mAh Ni-MH
From Category: Construction Equipment
Cat 740
Cat Dump Truck Kit is manufactured from aluminum die-cast, aluminum metal sheets and high quality plastic components. Kit comes with poweder coat finish and detailed assembly instructions. Kit components are: chassis, front and rear vehicle unit, superstructures, differentials, steering and lifting cylinders, proportional control of the steering cylinders, hydraulic pump with filter, operating at a working pressure of 174 psi. Two control valves, hose, T-pieces, lock bushings, hydraulic oil, electrical system, electric motor, battery pack 12V, 3 speed all wheel gearbox, and speed controller including a sound system with speaker. The axles are equipped with internal plantetary gears at reduction ratio of 15:1. NOTE: Radio, servos and charger are additional.
CAT01 Excavator
Hydraulic Excavator CAT 345D Scale 1:14.5Complete Assembly Kit #3120 consisting of:Upper and lower vehicle sections, chain drive with 2 electric motors, lower vehicle section in classic H-shape, driver’s cab and super-structures, raising and excavating cylinders, hydraulic pumps with tilter and 174 psi (12bar) operating pressure, three control valves, hoses, T-pieces lock bushings, hydraulic oil, electronics with light and sound system, loud speaker, batter pack 12V 2.7Ah and speed controller.The model distinguishes itself with its very high wrenching and braking-away force capabilities. As was the case with the CAT 966G II and CAT 740, this model is also manufactured out of die cast aluminum, aluminum sheet and high quality plastic material. All metal parts, including the hydraulic cylinder, are powder coated. NOTE: Radio, servos and charger are additional.
Caterpillar 966G
Caterpillar 966G Wheel Loader Kit. Constructed primarily of aluminum components and plastic trim parts. Operating as the real machine does with a hydraulic system capable of 174 psi. The drive system is a 6,000 rpm high torque 12V electric motor coupled to an all-metal 3-speed transmission and in turn coupled to two metal differentials at a 15:1 reduction ratio. Transmission and rear ends operate on a full set of ball bearings. All kit components are supplied with a durable baked on powder coat finish. Options necessry for R/C operation. NO PAINTING NECESSARY!
Dozer01
Dozer Base Kit NO hydraulics, NO electrical. The kit PR 742 dozer is made of metal, parts are pre-cast and accurate fitting. The kit can be assembled with standard tools. The body parts and Blade are made of 1.5mm thick hard rolled aluminum. The finished carriers of the tracks are made of aluminum. The tracks and entrance panel are punched out of steel sheets. Guiding wheels are ball bearing and supported by pre tensioned coil springs. Like the original, the model has swinging tracks. The hood can be taken off, the cabin tilts for battery access and the doors can be opened. The drive system is part of the kit. It is driven by 2 electric motors directly connected and sealed to spur gear transmission. The blade will be lifted by a servo in the standard version but, can be upgraded to a hydraulic set, which is offered separately. The kit contains all necessary parts to build the construction model. Options are required for R/C operation. PARTS ARE NOT PAINTED.
Dozer02
Ripper kit with Hyd's for Ripper and Blade
Dozer03
Servo for Hyd's (2 Required)
Dozer04
Hyd's for BLADE ONLY
Dozer05
Servo for Hyd's (1 Required)
Dozer06
Cab Interior For Dozer
Office: (480)655-7950 FAX: (480)655-7951 eMail: GardenTrucking@yahoo.com Search: ©2010 Precision Model Distributors, Inc. All rights reserved worldwide. | Top*Do to fluctuations in US dollar to Euro exchange rate, all pricing is subject to change without notice.
